AUTOLITE is an industry-leading provider of Emergency Exit Signs, Emergency Lighting and Fixtures, Specialty Signs, Lighting and Accessories. We have everything you need to get the job done on time and within the budget.

Backup lights perform normally in the presence of thin smoke, but poorly in the presence of thick smoke. This is because smoke particles prevent them from illuminating the surrounding area. An emergency light in thick smoke resembles a headlight in thick fog.

Code is pretty specific in requirements which can be viewed at our NFPA 101 Life Safety Code Page.

It depends on ambient temperature and location. However, the batteries that power the lights typically last up to 4/5 years before replacements are required.

Because power failures and emergency situations are unpredictable, fire marshals, electrical inspectors, building owners and others want to know that emergency lighting equipment will function properly when needed. Codes and regulations require periodic testing, visual inspections and written records of test results for all emergency lighting equipment.

There are many advantages in using LED technology for emergency lighting over incandescent and fluorescent lamps. Mainly for their low running costs and energy performance. LED’s are today’s chosen choice for the majority of Emergency Lighting manufacturers.

Non maintained Emergency Lighting is a luminaire which will only be lit from its battery back up in the event of a mains failure. A maintained luminaire can operate in normal operation and can be switched along with all other normal luminaires. In the event of a loss of mains power the luminaire will be lit from its battery back up but will have a lower emergency output.

Lighting level requirements state that designers must be able to achieve a minimum of 1 lux anywhere on the centre line of the escape route. This illuminance must be provided for the full 3-hour duration and maintained throughout the emergency luminaires life.

Typically, one should be visible from anywhere in common areas. For further clarification, a Autolite can do a walk through to determine what is needed per code and manufacture specifications.

Yes, we do provide AMC service. That, however, is applicable only on exhaustion of the product’s warranty period.

Yes, we do provide spares and accessories.

AUTOLITE Photoluminescent Signages products work by absorbing ambient light (photons) and storing it like a battery. When lighting is removed, these products project light (release photons) immediately, producing a sustained glow that can last for more than 8 to 10hours.

All AUTOLITE Photoluminescent Signages products are non-toxic, non-radioactive and contain no phosphorus or lead, or any other hazardous element or chemical.

The "Life" of the photoluminescent rigid sheet (indoors) is 20 to 30 years, while that of the photoluminescent aluminum sheet (outdoors) is 5 to 7 years. The Warranty period is 1 year.

Yes, we do provide persons for installation, and we can also assist and guide you or the contractor regarding the installation.

Photoluminescent safety signages that have a resin covering with photoluminescent substances in its composition.

The photoluminescent signage has the purpose of effectively transmitting the message for which it was manufactured, i.e. to show alarm equipment, fire equipment, security equipment, etc.). It also shows escape routes (exits, doors, etc.), the dangers, the obligations or the prohibitions, guaranteeing total understanding, even in blackout situations.

The adaptation of AUTOLITE products to the market's needs and to the national and international normative requirements is assured by a process of continuous investment, in innovation and development of new products and new technological solutions.

An exit route is the route of travel within the premises that occupants are most familiar with. It also normally routes that is used to enter and leave the building. A Fire exit is an alternative route of travel and one that is provided specifically for use in an emergency situation.

International standards recommend that, for a means of escape route signing system to be effective, it is important that from any place within the building, occupants should have sight of a sign, or a series of the sign, which lead them to a place of safety. If there is a choice of escape routes, the escape route signing system should indicate the shortest level of distance. If at any place there is a choice of two escape routes of equal travel distance. Both routes should be indicated by separate series of signs.

Because we have been in this area for years, with years of experience and good quality control, we really like to listen to what our customers really need and keep doing technical and research to make our product different from others.